Escalade ESV AWD V8-6.2L (2007)
11. Remove the brake pads from the caliper bracket.
12. Remove the retaining springs.
Installation Procedure
1. Install the retaining springs to the caliper bracket.
2. Install the brake pads.
3. Install the caliper to the caliper bracket.
4. Install the brake caliper guide pin bolts to the caliper bracket. DO NOT tighten.
5. Install the caliper and caliper bracket (1) as an assembly.
6. Perform the following procedure before installing the caliper bracket bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
Notice: Refer to Fastener Notice.
7. Install the brake caliper bracket mounting bolts (2).
