Escalade ESV AWD V8-6.2L (2007)
Tighten the bolts to 200 N.m (148 lb ft).
8. Tighten the brake caliper guide pin bolts.
Tighten the bolts to 108 N.m (80 lb ft).
9. Install the tire and wheel assembly.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained to properly seat the brake caliper pistons and brake pads.
13. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling.
