Escalade ESV AWD V8-6.2L (2007)
1. Install the fuel/EVAP lines to the vehicle.
2. Install the fuel line bracket locator tab to the frame.
3. Install the fuel/EVAP line clips to the frame and crossmember.
4. NOTE: Refer to Fastener Notice.
Install the fuel line bracket bolt (3).
Tighten the bolt to 12 N.m (106 lb in).
5. Remove the caps from the fuel and EVAP lines.
6. Connect the chassis EVAP line quick connect fitting (4) to the fuel tank line.
7. Connect the fuel tank fuel feed line quick connect fitting (5) to the chassis line.
8. If equipped with 4WD, install the fuel hose/pipe clip to the bracket on the transfer case.
9. Install the fuel line clip to the bracket on the automatic transmission.
