Escalade ESV AWD V8-6.2L (2007)
Ride Height Sensor: Service and Repair
Electronic Suspension Front Position Sensor Link Assembly Replacement
Electronic Suspension Front Position Sensor Link Assembly Replacement
Tools Required
J 38185Spring Hose Clamp Pliers
Removal Procedure
Important: Do not attempt to pry the link rod from the electronic suspension control (ESC) ball stud. If the link rod needs to be replaced
or disconnected, you must use the following procedure.
1. Remove the ESC sensor from the vehicle.
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the mounting bracket ball stud.
Installation Procedure
1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the mounting bracket.
2. Install the ESC sensor to the vehicle.
