Escalade ESV AWD V8-6.2L (2007)
8. Install the control lever (2) to the manual shaft.
9. Install the control lever to the manual shaft nut (1).
Tighten the nut to 25 N.m (18 lb ft).
10. Connect the range selector cable to the range selector lever ball stud.
11. Connect the PNP switch electrical connector (1).
12. If equipped with 4WD, install the front propeller shaft.
13. Lower the vehicle.
14. Check the PNP switch for proper operation. The engine must start in the Park (P) or Neutral (N) positions only. If proper operation of the switch
can not be obtained, replace the switch.
