Escalade ESV AWD V8-6.2L (2007)
4. Install the drain plug (9.5 inch axle only).
Tighten the drain plug to 33 N.m (24 lb in).
5. Fill the rear axle with fluid.
The lubricant level should be between 0-13 mm (0-0.50 inch) below the fill plug opening.
6. If the level is low, add lubricant until the level is even with the bottom of the fill plug opening. Use the proper fluid, refer to Fluid and Lubricant
Recommendations.
7. Lower the vehicle.
Rear Axle Shaft Seal and/or Bearing Replacement (8.6, 9.5 LD Axles)
Rear Axle Shaft Seal and/or Bearing Replacement (8.6, 9.5 LD Axles)
Tools Required
^
J 8092 Universal Driver Handle - 3/4 in - 10
^
J 21128 Axle Pinion Oil Seal Installer
^
J 23690 Bearing Installer
^
J 2619-01 Slide Hammer
^
J 45857 Tone Wheel and/or Bearing Remover
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the tire and wheel assembly.
3. Remove the rear axle housing cover.
4. Remove the axle shaft.
5. To remove the seal only, use a suitable seal remover.
