Escalade EXT V8-6.0L VIN N (2004)
Installation Procedure
1. Install the head restraint by pushing down on restraint until the restraint is fully seated.
2. To ensure the head restraint is fully seated pull the head restraint up to the full upward position.
The head restraint must not come off the restraint rod.
Head Restraint Replacement (Folding)
Head Restraint Replacement (Folding)
The folding headrest cannot be replaced separately. Therefore if the folding mechanism has failed, the seat back frame needs to be replaced. Refer to
Seat Back Frame Replacement - Rear (60/40 Split - 50/50 Split) Seat Back Frame Replacement - Rear (Bench).
Head Restraint Retainer Replacement - Front Seat
Head Restraint Retainer Replacement - Front Seat
Removal Procedure
1. Slide up the seat back trim cover in order to gain access to the rear cardboard panel fasteners. Refer to Seat Back Cover and Pad Replacement -
Front (W/O ULT) Seat Back Cover and Pad Replacement - Front (W/ULT).
2. Remove the panel fasteners. Pull back the panel in order to gain access to the bushings.
3. Remove the head restraint retainers from the seat back frame by squeezing the retaining tabs together at the base of the guide(s) and lifting up.
Installation Procedure
