Escalade EXT V8-6.0L VIN N (2004)
5. Remove the control module (1) from the vehicle.
Installation Procedure
1. Install the control module (1) to the vehicle.
2. Connect the wiring harness (2) to the control module (3).
Important: If you are replacing the module, you must program the module by performing the following procedure.
^
Connect the scan tool to the data link connector (DLC).
^
Turn the ignition ON with the engine OFF. Select the SPECIAL FUNCTIONS for the RTD module on the scan tool.
^
Select the Recalibration line under SPECIAL FUNCTIONS and follow the instructions on the scan tool and techline terminal to complete the
RTD module programming.