Escalade EXT V8-6.0L VIN N (2004)
4. Install the wheel speed sensor wire from the ESC sensor bracket.
5. Install the wheel speed sensor wire to the ESC sensor bracket.
6. Connect the sensor harness connector to the vehicle harness connector.
7. Remove the safety stands.
8. Lower the vehicle.
Front
Front Position Sensor Link Assembly Replacement - Electronic Suspension
^
Tools Required
-
J 38185 Spring Hose Clamp Pliers
Removal Procedure
Important: Do not attempt to pry the link rod from the electronic suspension control (ESC) ball stud. If the link rod needs to be replaced or
disconnected, you must use the following procedure.
1. Remove the ESC sensor from the vehicle.
2. While supporting the sensor lever by hand, twist the link rod to remove it from the ball stud.
3. Remove the link rod from the mounting bracket ball stud.
Installation Procedure
1. Using the J 38185 install to link rod to the ball stud on the sensor lever and the mounting bracket.
2. Install the ESC sensor to the vehicle.
Rear
Rear Position Sensor Link Assembly Replacement- Electronic Suspension
^
Tools Required
-
J 38185 Spring Hose Clamp Pliers
Removal Procedure
