Escalade EXT V8-6.0L VIN N (2004)
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts to the frame.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Close the bracket around the upper control arm making sure the bracket rests between the locating stops.
4. Install the bolt.
^
Tighten the bolt to 25 Nm (18 ft. lbs.).
5. Connect the sensor harness connector to the vehicle harness connector.
6. Install the wheel and tire assembly to the vehicle.
7. Lower the vehicle.
Right
Rear Position Sensor Replacement -Electronic Suspension- Right
Removal Procedure
