Escalade EXT V8-6.0L VIN N (2004)
1. Raise the vehicle.
2. Remove the wheel from the vehicle.
3. Disconnect the sensor harness connector from the vehicle harness connector.
4. Disconnect the sensor link from the ball stud.
5. Remove the bolts.
6. Remove the position sensor from the vehicle.
Installation Procedure
1. Install the position sensor on the vehicle.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the bolts.
^
Tighten the bolts to 12 Nm (106 inch lbs.).
