Escalade EXT AWD V8-6.2L (2009)
Warning
Do not depress the brake pedal with the brake rotors/calipers and/or the brake drums removed. Damage to the brake system may result. If brake system
damage occurs and is not repaired, vehicle damage and/or personal injury or death may result.
11. Remove the brake caliper guide pin bolts from the brake caliper.
12. Remove the brake caliper from the caliper mounting bracket.
Installation Procedure
1. Install the brake caliper to the caliper mounting bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install brake caliper guide pin bolts and tighten to 108 Nm (80 lb ft).
3. Remove the cap or plug from the brake hose to caliper fitting.
Note: Install 2 NEW copper brake hose gaskets.
4. Assemble the 2 copper brake hose gaskets to the brake to caliper bolt and the brake hose.
5. Install the brake hose to caliper bolt and tighten to 45 Nm(33 lb ft).
6. Bleed the brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic Brake System
Bleeding (Pressure) (See: Brake Bleeding/Service and Repair)Hydraulic Brake System Bleeding (Two-mode Hybrid) (See: Brake
Bleeding/Service and Repair).
7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
8. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling (See:
