Escalade EXT AWD V8-6.2L (2009)
1. Install the dash panel exhaust heat shield (1 or 3) to the dash panel studs.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the dash panel exhaust heat shield nuts (2 or 4) and tighten to 9 Nm(80 lb in).
3. Install the catalytic converter, if required. Refer to one of the following:
*
Catalytic Converter Replacement (See: Catalytic Converter/Service and Repair/Catalytic Converter Replacement)
*
Three-Way Catalytic Converter Replacement (See: Catalytic Converter/Service and Repair/Three-Way Catalytic Converter Replacement)
4. For 2500 series vehicles, position the oil pan skid plate and tighten until snug the 2 rear oil pan skid plate bolts. Install the 2 front oil pan skid plate
bolts, if equipped and tighten the bolts to 28 Nm(21 lb ft)
