Escalade EXT AWD V8-6.2L (2009)
Power Trunk / Liftgate Control Module: All Technical Service Bulletins
Power Liftgate - Liftgate Open/Rear Access Open
TECHNICAL
Bulletin No.: 09-08-64-024
Date: June 08, 2009
Subject: Power Liftgate "Liftgate Open" or "Rear Access Open" DIC Message Turn Off Delay, Liftgate Reverses While Closing (Reprogram Power
Liftgate Module)
Models:
2009 Buick Enclave
2009 Cadillac Escalade, Escalade ESV, Escalade EXT (all built after January 1, 2009)
2009 Cadillac SRX
2009 Chevrolet Suburban, Tahoe (all built after January 1, 2009)
2009 Traverse
2009 GMC Acadia
2009 GMC Yukon, Yukon XL, Yukon Denali, Yukon XL Denali (all built after January 1, 2009)
2009 Saturn OUTLOOK
All Equipped with Power Liftgate (RPO E61)
Condition
Some customers may comment that the Power Liftgate may have one or more of the following concerns:
-
The "Liftgate Open" or "Rear Access Open" message on the DIC does not immediately turn off after the liftgate is fully closed.
-
The courtesy lamps do not go into theater dimming immediately after the liftgate is fully closed.
-
The Liftgate reverses while closing.
During diagnosis, the technician may also observe the Tech 2(R) "Close History Data" stating an "Obstacle Detected."
Cause
The Power Liftgate Module delays reporting the liftgate latch's state. The module is not communicating that the liftgate is FULLY closed in a timely
fashion. The time delay for reporting the latch state is between 200 msec and 20 seconds.
Correction
Important
DO NOT replace the liftgate latch or the Power Liftgate Module for this concern.
Reprogram the Power Liftgate Module with the revised calibration.
Important
Select the correct calibration files for the appropriate vehicle configuration (body style) and RPO codes.
A revised calibration has been developed to address this condition. Technicians are to reprogram the Power Liftgate Module using the Service
Programming System (SPS) with the latest software available on TIS2WEB. Refer to the Liftgate Control Module Programming and Setup procedures in
SI. As always, make sure your Tech 2(R) is updated with the latest software version.
Warranty Information
For vehicles repaired under warranty, use the table above.
