Escalade EXT AWD V8-6.2L (2009)
11. Position the tripot end of the wheel drive shaft assembly into the base of the J-36652-98 - tool for the 1500 models or J-36652-1 - tool for the
2500, 3500 models.
12. Install the top half of the J-36652-98 - Tool for the 1500 models or J-36652-1 - tool for the 2500, 3500 models.
13. Align the boot clamp (2) and the clamp.
Note: Hand tighten the bolts until the bolts are snug.
14. Insert the bolts.
15. Align the tripot boot, tripot housing, and the boot clamp.
Note: Alternate between the bolts until both sides of the top half of the tool touch the bottom half.
16. Tighten each bolt 180 degrees at a time.
17. Loosen the bolts and remove the halfshaft assembly from the tool.