Fleetwood V8-368 6.0L VIN 9 FI (1982)
10.
With both "O" rings greased, install new adapter pipe into intake manifold as far as it will go as shown in Figure 1.
11.
Using, a new "O" ring at water pump, install the lower thermostat housing.
12.
Install the two bolts at lower thermostat housing; do not tighten.
13.
Slide adapter into thermostat housing, keeping the loose ring and "O" ring in the manifold.
14.
Install spring clip between stationary rib and loose ring.
15.
Tighten the two bolts at lower thermostat housing.
16.
Install A/C compressor front adjustment brace to lower thermostat housing.
17.
Install vacuum hose to vacuum pump.
18.
Install engine water temperature sensor.
19.
Install thermostat.
20.
Fill with coolant.
21.
Check for leaks.
For warranty purposes, when installing only the thermostat adapter pipe (steps 1 through 16), use Labor Operation No. T6098 at .6 hour.
