cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

All Technical Service Bulletins for Sun Gear: > < Park/Neutral Switch, Automatic Trans.|Page 1964
Page 1
background image

Sun Gear: Customer Interest
A/T - No Reverse, First Gear Only

Bulletin No. T   

84-57

File In Groups   

7

Number     

96

Date

Mar. '84

SUBJECT:

NO REVERSE, FIRST GEAR ONLY

MODELS AFFECTED:

1979-1984 DEVILLE, BROUGHAM, ELDORADO AND SEVILLE

FIGURE 1 - INPUT DRUM SPLINES INSPECTION

1979-1984 Cadillacs equipped with THM 200, 200C, 200-4R, 325 and 325-4L transmissions may experience a lack of engagement in reverse, second,
third and fourth gear while operating properly in first gear. This condition can be caused by stripped input drum to rear sun gear splines (refer to Figure
1) and does not affect line pressure readings or cause worn clutch plates or bands.
The purpose of this bulletin is to inform technicians performing overhaul procedures for this condition that careful inspection of the input drum splines
and planetary gear assemblies is necessary. Spline wear may not be completely obvious during disassembly since the splines may hold with hand torque
but not with engine torque.

To inspect the splines properly, remove the snap ring used to retain the input drum to the sun gear shaft and remove the input drum from the sun gear. If
any wear is present, replace the sun gear shaft along with the input drum.

All Technical Service Bulletins for Sun Gear: > < Park/Neutral Switch, Automatic Trans.|Page 1964