Fleetwood Brougham V8-307 5.0L (1989)
ESC Wiring Diagram
CIRCUIT DESCRIPTION:
If the timing is retarded at idle, it may be due to ESC operation. ESC should not operate unless a knock is present.
TEST DESCRIPTION: Numbers below refer to circled numbers on the diagnostic chart.
1.
This is the ESC functional check. Simulating an engine knock by tapping the engine block should normally cause an rpm drop (decrease timing). If
it does not drop, either the timing is not retarding or is retarded all the time.
2.
This should cause full retard by dropping the voltage at ECM terminal "L." Retarded timing should cause an rpm drop.
3.
Normally, voltage should be 0.08 volt AC, or higher for a good knock sensor circuit.
4.
"SERVICE ENGINE SOON" light should be "ON" and a Code 43 set because ESC system would be retarded too long. If no light "ON," the ECM
is not retarding the spark because of a voltage on CKT 457 to terminal "L" or the ECM is faulty.
5.
Checks to see if knock sensor is reason for retard signal. If engine knock is not present, and timing increases when knock sensor is disconnected,
fault is an over sensitive knock sensor. Timing should not normally increase.
6.
Checks to see if retard signal is due to "noise" on signal wire or faulty controller. If timing increases when wire is disconnected from controller,
fault is due to knock sensor signal wire running too close to an ignition or charging system wire. Reroute wire to correct.
