Fleetwood Brougham V8-307 5.0L (1989)
Figure 4
3. Verify upper door trim pads are flush to door inner at front edge on both the front and rear doors. Refit if necessary. Refer to Figure 4.
4. Pull down the front door vandow run channels and seal to door header with silicon sealer. Pay close attention to the areas around the blow out clips
to obtain a good seal. Refer to Figure 5.
Figure 5
5. Seal the front and rear door upper frame moldings to the door header with silicon sealer. Refer to Figure 5.
6. Verify door hem flanges are sealed to door inner panel around entire periphery of door. Fill any voids with thumb grade sealer. Refer to the 1990
Service Information Manual, page 10-1-10, Figure 10-1-19.
7. Remove rear door upper frame 7 mm screw that retains rear vent divisional channel to door header. Force clear silicon sealer into the screw hole to
fill the pocket between the door upper frame and divisional channel.
