Fleetwood FWD V6-260 4.3L DSL (1985)
FIGURE 2
On hard top vehicles remove the rear door window opening molding (refer to Figure 2). This molding is retained with clips that can be accessed by
removing the press-in rubber lace trim from between the molding and the door on the top, front and rear sides. The lace is bonded to the molding on
the bottom side. Do not separate the lace from the molding on the bottom side. To disengage the molding from the lower clips, push the molding
downward and pull outward (away from the door) at the top.
FIGURE 3
2.
With the rear door window opening molding or trim removed, the rubber channel between the stationary vent glass and the door can be accessed.
Use a hardening type body sealant (3M #08501 All-Around Body Sealant or equivalent) to fill any voids between the vent glass rubber channel
and door (refer to Figure 3).
3.
Allow adequate sealant cure time (per manufacturer's directions). Install the window opening molding or trim by performing the removal
procedure listed in step 1 in reverse..
For warranty purposes, use Labor Operation T6201 for .4 hours on the right rear door and T6202 for .4 hours on the left rear door.
