Fleetwood FWD V8-252 4.1L (1986)
Figure 2 - Governor Orifice Inspection
8.
Remove bottom pan, inspect accumulator cover and governor retainer for damage of gaskets and/or sealing surfaces. Inspect governor orifice for
damage or missing orifice plug (refer to Figure 2). Inspect and remove any foreign material that may be lodged in this area.
Figure 3 - Control Valve Assembly Inspection
9.
Governor pressure below 3.0 PSI (21 kPa) at 0 mph (0 kmh) indicates the 1-2 shift valve is in the upshifted position. Remove the control valve
assembly. Refer to the appropriate Service Information Manual. Inspect for the following conditions:
^
Sticking 1-2 shift valve (331).
^
Sticking 1-2 throttle valve (332).
^
Binding 1-2 throttle valve spring, due to a mispositioned 1-2 throttle valve bushing retainer (390).
^
Ensure the throttle valve bushing retainer (390) is installed flush with the mating surface of the control body casting (363).
For warranty purposes, use the following Labor Operations:
Labor
Time
Allowance
Steps
Operation
C
E, K
1-4
T6208
1.3
1.3
1-8
T6209
1.6
1.6
1-6&9
T6210
4.8
5.3