cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

All Technical Service Bulletins for Coolant Temperature Sensor/Switch (For Computer): > < Wheel Speed Sensor Replacement|Page 297
Page 1
background image

Coolant Temperature Sensor/Switch (For Computer): Customer Interest
A/C - Intermittent Hot Air or Heat From ECC System

Bulletin No.

T-89-91A

File in Group

1

Number

61

Corp. Ref. No.

911101R

Date

April, 1989

SUBJECT:

INTERMITTENT HOT AIR OR HEAT FROM ECC SYSTEM

MODELS AFFECTED:

1985-1987 DE VILLES AND FLEETWOODS

This bulletin supersedes, Group 1, date 4/89 which should be discarded. The CTS part number in step 1b was incorrect.

Some 1985-1987 Fleetwoods and DeVilles may experience a condition of hot air out of the heater or A/C ducts intermittently. This may be caused by a
poor connection, or faulty Coolant Temperature Sensor (CTS).

Engine coolant temperature is used by the BCM to help determine air mix door position. If the BCM sees a low coolant sensor reading, it moves the air
mix door more toward the max heat position to compensate for a cooler heater core.

To repair this condition the following procedure should be used during the condition*:

Enter BCM parameters and select P.2.1.

1.

If the car has been running for more than 10 minutes and the CTS reading is less than 70~ Celsius, perform the following:

a.

Disconnect and jumper the CTS connector leads together; P.2.1 should read 151. If the reading is below 150, there is a high resistance point
in the circuit. Measure resistance in circuits 410 and 476 from the ECM to CTS. Check the wire showing resistance above 1 ohm for damage
or a poor connection.

b.

If the jumpered CTS circuit reading is 151, replace the sensor, PN 25036979. On 1985 models when replacing the sensor, replace the CTS
connector with metropak connector, P/N 12046623. Parts are currently available from GMSPO.

2.

If the CTS reading is correct during the condition, perform the ECC diagnosis in Sections 1C, 8A-62, or 8A-64.

For warranty purposes use Labor Operation J6368 at .5 hour.

*

This procedure will only work when the vehicle exhibits this condition. To duplicate this condition it may help to cycle the CTS and ECM
connectors, and wiggle circuits 410 and 476 wiring.

All Technical Service Bulletins for Coolant Temperature Sensor/Switch (For Computer): > < Wheel Speed Sensor Replacement|Page 297