Fleetwood FWD V8-300 4.9L (1993)
6.
Water test to ensure the repair is satisfactory.
7.
Reinstall the windshield garnish molding and the center pillar trim.
For vehicles repaired under warranty use Labor Operations T3345 (RH front door) and T-3346 (LH front door). Use published Labor Operation time.
Rear Door Primary Weatherstrip Leak
1.
Remove the rear seat assembly. Refer to Service Information Manual, Section 10-10-16.
2.
Remove center pillar trim.
3.
Remove quarter upper trim and lock pillar trim.
4.
By grasping and pulling with your hand, detach the weatherstrip from its flange. The portion of the weatherstrip flange may be left in place.
5.
Examine the joints in the weatherstrip flange. If gaps at the flange joints exist, fill the gaps with sealer.
6.
Apply a continuous bead of sealer to the weatherstrip cavity from the front corner of the rocker area around to the rear corner of the rocker area.
7.
Reinstall the weatherstrip to the weatherstrip flange.
8.
Water test to ensure repair is satisfactory.
9.
Reinstall the quarter trim.
10.
Reinstall the rear seat assembly.
11.
Reinstall the center pillar trim.
For vehicles repaired under warranty use Labor Operations T3347 (RH rear door) and T3348 (LH rear door). Use published Labor Operation time.
III. REAR COMPARTMENT LEAKS
Materials Required For Rear Compartment Leaks - Seam Below Back Window and Deck Lid Weatherstrip) To Flange
^
3M P/N's 08302 or 08405
^
Dominion/American Sure Seal P/N LSC
^
Kent P/N 10500, or equivalent
To Repair The Seam Below The Back Glass
