Fleetwood FWD V8-300 4.9L (1993)
1.
Remove the rear door stationary glass per Section 10 of the Service Information Manual.
2.
Starting at the top of the division post and continuing rearward to the bottom of the stationary glass opening, apply a bead of bedding and glazing
compound to the inboard edge of the retainer. Refer io Figure 7.
3.
Fill the two cavities at the lower corner of the stationary glass channel with strip caulk sealer. Refer to Figure 7.
4.
Reinstall stationary glass.
5.
After the glass is reinstalled, tape the rubber flap to the door as shown in Figure 7 to close off any openings.
NOTE:
When reinstalling stationary glass, care should be taken to ensure that the stationary glass seal is parallel with the belt line molding. The seal flap around
the perimeter of the stationary glass must be outboard of the reveal molding.
For warranty purposes use Labor Operations C0400 for the right door and C0401 for the left door at 1.0 hour per door.
B-Pillar Seal to Rear Door
XII. Wind rush due to gap condition at B-Pillar seal to rear door.
1.
Remove retaining screws and B-Pillar seal.
