Fleetwood FWD V8-300 4.9L (1993)
Engine Mount: Service and Repair
Fig. 4 Engine & Transaxle Mounts. 4.9L
Right Side Removal
1.
Disable airbag system as described under MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.
2.
Relieve fuel pressure as outlined under MAINTENANCE PROCEDURES/FUEL SYSTEM PRESSURE RELIEF.
3.
Open hood, then remove engine bracket to engine brace.
4.
Remove engine bracket to mount attaching nuts.
5.
Raise and support vehicle.
6.
Using suitable jack stands, support vehicle at each front frame horn.
7.
Remove two nuts on engine mount securing it to frame. Fig. 4.
8.
Remove two nuts securing transaxle bracket to mount.
9.
remove two nuts securing transaxle mount to frame bracket. Install engine support tool No. J 28467 or equivalent, then raise engine until bracket is
clear of mounts.
10.
Remove stud and two bolts that secure bracket to block, then pull mount and bracket forward to remove.
11.
Remove transaxle mount bracket, then mount assembly.
Install or Connect
1. Position engine mount and bracket in place between cylinder block and frame. Secure bracket to block with one stud and two bolts.
-
Tighten to 46 Nm (34 lb.ft.)
2. Position transaxle mount and bracket in place between transaxle and frame. Secure bracket to transaxle with two bolts.
-
Tighten to 46 Nm (34 lb.ft.)
