Fleetwood FWD V8-300 4.9L (1993)
Drive Belt Idler And Coolant Pump Pulleys
REMOVE OR DISCONNECT
1. Battery cables and battery.
2. Drain coolant.
3. Coolant pump pulley. Apply tension to drive belt to keep pulley from rotating by forcing belt tensioner into drive belt with breaker bar.
4. Accessory drive belt.
5. Water pump.
6. Raise vehicle.
7. Wheelhouse engine splash shield.
8. Lower coolant pump bolts.
9. Lower vehicle.
10. Remaining coolant pump bolts.
11. Coolant pump.
12. Coolant pump gasket and discard.
CLEAN
^
Coolant pump and engine front cover sealing surfaces.
INSTALL OR CONNECT
1. New coolant pump gasket on front cover studs.
2. Coolant pump.
3. Upper bolts hand tight.
4. Raise vehicle.
5. Lower bolts.
TIGHTEN
^
Lower coolant pump fasteners to specifications.
6. Wheelhouse engine splash shield.
7. Lower vehicle.
TIGHTEN
^
Upper coolant pump fasteners to specifications.
8. Coolant pump pulley and install screws finger tight.
9. Accessory drive belt.
TIGHTEN
^
Coolant pump pulley bolts to 30 Nm using drag of drive belt to hold pulley. If additional drag is needed, attach breaker bar to belt tensioner
and apply load to belt while tightening pulley bolts.
