Removing Refrigerant Filter From Fleetwood FWD V8-300 49L (1993)
-
Remove caps or tape from open ends at condenser assembly outlet fitting and evaporator inlet port.
-
Coat new 0-rings with clean 525 viscosity refrigerant oil GM PIN 5416939 or equivalent and install them.
-
Tighten nuts, holding the fitting of condense outlet tube stationary with a second wrench.
-
Tighten
-
Nut at condenser outlet fitting to 16 Nm (12 lbs. ft.).
-
Nut at evaporator inlet port to 16 Nom (12 lbs. ft.).
6.
Refrigerant.
-
Partially charge system and perform a leak test. Refer to System Diagnosis / Leak Test.
See: Testing and Inspection-
Recover refrigerant, and evacuate and charge system. Refer to Service and Repair / Charging the System. See: Service and Repair
-
Test system performance. Refer to System Diagnosis / Performance Test. See: Testing and Inspection
