Fleetwood FWD V8-300 4.9L (1993)
6. Remove bleeder valve cap and place proper size box-end wrench, J 28434, or J 21472, over caliper/cylinder bleeder valve.
7. Attach a transparent tube to bleeder valve, submerge other end of tube in a clear container partially filled with clean brake fluid.
8. Depress brake pedal slowly one time and hold.
a. Loosen bleeder valve to purge air from the caliper/cylinder.
b. Tighten bleeder valve, and slowly release brake pedal.
c. Wait 15 seconds, then repeat the sequence, including the 15 second wait, until all air is removed. This sequence may have to be repeated 10 or
more times to remove all the air.
NOTE: Rapid pedal pumping pushes the master cylinder secondary piston down the bore in a way that makes it difficult to bleed the system.
TIGHTEN
^
Wheel cylinder bleeder valves to 7 Nm (62 lb. in.).
^
Caliper bleeder valve to 13 Nm (10 lb. ft.).
9. Install bleeder valve caps.
10. Lower vehicle.
11. Fill master cylinder to proper level.
12. Check brake pedal for "sponginess."
^
Repeat entire bleeding procedure to correct "sponginess."
