Fleetwood FWD V8-300 4.9L (1993)
1.
Twist the quick connector 1/4 turn in each direction to loosen any debris within the connector.
2.
Using compressed air, blow the debris out of the connector.
3.
Squeeze the plastic tabs of the male end connector and pull apart.
CONNECT:
1.
Using a clean shop towel, wipe off the male pipe end.
2.
Apply a few drops of clean engine oil to the male pipe end.
3.
Push the connector onto the male pipe end until the plastic tabs snap into place.
4.
Check that the connector is locked on by trying to pull the connector away from the male pipe end.
...............................................................................................................................................................................................................................................
3.
Remove the fuel pipe from the attaching clips and remove it from the vehicle.
INSTALLATION:
1.
Install the new pipe following the same routing.
2.
Install new attaching clips.
3.
Connect the fuel pipe quick connectors.
4.
START the engine and check for fuel leaks.
