Full Size Cad RWD V8-350 5.7L DSL (1984)
8.
Obtain Bushing Kit (P/N 25111444). Install the bushing onto the bail as shown in figure 3, so that the two tabs snap firmly in place. If the bail is
bent (or twisted) so that the new bushing will not easily snap into place on the bail (as shown in figure 3), straighten the bail as necessary.
Figure 2
Figure 4, As Assembled
9.
Install the Clip over the bushing and bail as shown in Figures 3 & 4.
Reinstall the Servo Rod Assembly through the new bushing by positioning the "Z" pin as shown in the View "A" of Figure 2. Reinstall the original
Spring Retainer in the original (marked) hole in the rod, pointing the Spring Retainer in the direction shown in Figure 4.
If the Servo Rod Assembly is missing the "Z" pin, install a second Spring Retainer (provided in Bushing Kit) in the end hole normally occupied by
the "Z" pin.
10.
Ensure that the throttle mechanism will return fully to the idle position.
11.
Reinstall the air cleaner assembly and reconnect hose and electrical connections as may be appropriate.
12.
Install a Campaign Completion Label, remove fender cover from left fender, and close hood.
Campaign Label and Credit Information
CAMPAIGN COMPLETION LABEL
