Seville V8-273 4.5L (1989)
Figure 2
5. Apply a bead of Loctite(R) Black Max(TM) 380 Adhesive to the glass panel molding/weatherstrip seal contact area. Refer to Figure 2.
6. Begin installation of the weatherstrip seal at either side of the glass panel. The position of the end of the weatherstrip determines the location of the
weatherstrip butt joint. The butt joint must be positioned near the center of either the right or left side of the sliding glass panel (the shorter sides of
the panel). THE BUTT JOINT CANNOT BE POSITIONED ON THE FRONT OR REAR OF THE PANEL (the longer sides). Refer to Figure 2.
7. Install weatherstrip seal around the sliding glass panel, making sure that the weatherstrip is tight against the glass panel molding. When you are
