Seville V8-273 4.5L (1989)
within approximately six inches of the starting point allow the weatherstrip to hang free from the molding. Overlap the free end and the installed end
of the seal as shown in View A of Figure 2.
8. Cut the weatherstrip seal, allowing 1/8-3/16 inches (3-5 mm) overlap of the two ends as shown in Figure 2. Be careful to cut the weatherstrip off
squarely.
9. Apply a small amount of Loctite(R) Black Max(TM) 380 Adhesive to each end of the weatherstrip seal.
Figure 3
