Seville V8-273 4.5L (1989)
3.
Tape underside of housing to contact rivet slug. Place tape over cable opening in track to prevent drill shavings from entering track.
4.
Use a 7/32" (5 mm) drill to remove only the head of the rivet, two rivets each side. Use caution not to drill through the housing or headliner.
Drilling through the housing may make the hole too large for the rivets supplied in the kit.
5.
Carefully knock out the rivet slugs and remove tape from underside of housing. Remove metal shavings and tape from top of tracks. Use of an air
hose to blow the drill shavings from the housing is not recommended as some shavings may be blown into the cable track.
6.
Remove two pivot plates by prying up to release plate from the track.
7.
Position the new pivot plate (from kit, P/N 12500028) onto the track lining up the rivet holes. The plates are identified as right-hand (RH) or
left-hand (LH) on the bottom side. Tap the plate with a hammer to seat it over the raised staking area on the track. Ensure that the plate is flush to
the track surface prior to riveting.
8.
Secure the two pivot plates using the four black rivets supplied in the kit.
9.
Reinstall headliner and trim lace.
For
warranty purposes use Labor Operation T6429 at .6 hour.
Figure 4 - Glass Panel Loop Material Locations
Isolation of Sunshade, Air Deflector, Shield
To isolate components and eliminate rattles in the rest of the sunroof assembly, complete all of the following steps on 1988 and 1989 vehicles. Add loop
material (soft loop half of hook-and-loop fastener system, such as Velcro(R) or Scotchmates(R) Hook and Loop Fastener, 3M P/N 06480) in the
following locations as required:
1.
Remove sunshade. Open glass panel part way.
2.
Add loop material (40 mm long) at the front of the glass panel on the underside. Refer to Figure 4 for locations. This prevents air deflector rattles
against the bottom of the glass panel.
3.
Add a small pad (10 mm) of loop material at the top front corners of the track. Locate pad so deflector rests on it when closed.
Figure 5 - Restrike Sunshade Toggle Locks
