Seville V8-273 4.5L (1989)
5.
Remove two nuts securing transaxle bracket to mount.
6.
Remove two nuts securing transaxle mount to frame bracket.
7.
Raise engine using support J-28467 or equivalent, lifting engine until bracket is free from engine and transaxle mounts.
8.
Remove stud and two bolts securing bracket to block, then the bracket and mount by pulling forward.
9.
Remove transaxle mounting bracket from transaxle, then the mount.
Installation
Refer to Fig. 1, for engine and transaxle mount position.
1.
Position engine mount and bracket between block and frame, then torque bracket bolts and stud to specifications.
2.
Position transaxle mount and bracket between transaxle and frame, then torque bracket retaining bolts to specifications.
3.
Guide mounts into position while lowering engine and reverse remaining procedure to complete installation, torquing all fasteners to
specifications.
LEFT ENGINE MOUNT
Refer to Fig. 1, for engine and transaxle mount position.
1.
Open hood, disconnect battery ground cable, then remove air cleaner assembly.
2.
Remove serpentine drive belt, then discharge A/C system and recover coolant.
3.
Install engine support tool No. J-28467 or equivalent.
4.
Remove lower center exhaust manifold nut and top nut from engine damper.
5.
Raise and support vehicle, remove right engine splash shield, then A/C splash shield.
6.
Remove engine damper.
7.
Remove two A/C compressor brackets, then the A/C compressor.
8.
Remove water pipe bracket bolt.
9.
Remove bolts securing engine mount bracket to block and cradle.
10.
Remove engine mount and bracket assembly through right wheelwell.
11.
Remove engine mount from bracket.
12.
Reverse procedure to install, torquing engine mount fasteners to specifications.
