Seville V8-273 4.5L (1989)
Exhaust System Test at Oxygen Sensor
CHECK AT 02 SENSOR:
1. Carefully remove O2 sensor.
2. Install Exhaust Backpressure Tester in place of 02 sensor.
3. After completing the diagnosis described below, be sure to coat threads of 02 sensor with anti-seize compound prior to re-installation.
DIAGNOSIS:
1. With the engine idling at normal operating temperature, observe the exhaust system backpressure reading on the gauge. The reading should not
exceed 1.25 psi or 8.6 kPa. Increase engine speed to 2000 rpm and observe gauge. The reading should not exceed 3 psi or 20.7 kPa.
2. If the backpressure exceeds the given specifications, a restricted exhaust system is indicated.
3. Inspect the entire exhaust system for a collapsed pipe, heat distress, or possible internal muffler failure.
4. If there are no obvious reasons for the excessive backpressure, a restricted catalytic converter should be suspected, and replaced.
