Seville V8-273 4.5L (1989)
Ride Height Sensor: Adjustments
When repair or adjustment procedures require that vehicle be raised on a hoist, it is important that the rear axle assembly remains in the
normal trim height position at all times. When a frame contact hoist is used, two additional jack stands should be used to support the rear axle
or control arms in the normal trim height position.
The link should be properly attached to the sensor arm and track bar, when making this adjustment.
1.
Loosen lock bolt that secures metal arm to height sensor plastic arm.
2.
To raise vehicle trim height, move plastic arm upward and tighten lock bolt.
3.
To lower vehicle trim height, follow step 1 and move plastic arm down.
4.
If adjustment cannot be made, check for correct sensor.
