Seville V8-273 4.5L (1989)
Fig. 32 Inner Clamp & Air Bladder Position
Installation
1.
Lubricate new O-ring and O-ring groove with silicone lubricant. Install O-ring in groove, Fig. 29.
2.
Apply silicone lubricant to inside top of new air bladder and the entire outside of air bladder, Fig. 31.
3.
Fold bottom of air bladder before installation on inner tube. Place air bladder over inner tube, continuing to fold bladder from the bottom up.
Position top of air bladder as shown in Fig. 32. Do not use tools to fold air bladder as damage may occur, causing air leakage.
4.
Place inner clamp in position as shown in Fig. 32. Tighten clamp with tool J-34649.
5.
Fold bottom of air bladder upward and fold top of 4 inch section downward.
6.
Apply silicone lubricant to polished diameter of inner shaft tube.
7.
Place outer tube over air bladder and push downward against folded portion of bladder. The outer tube must be completely seated over shaft.
Fig. 33 Air Fitting Position
