Seville V8-273 4.5L (1989)
Wheels: All Technical Service Bulletins
Aluminum Wheels - Damage During Balancing
Bulletin No.: T-93-99
File in Group: 3
Number: 22
Corp.Ref.No.: 393502
Date: May, 1993
SUBJECT:
INFORMATION ON COSMETIC DAMAGE TO ALUMINUM WHEELS DURING BALANCING
MODELS AFFECTED:
1988-1993 CADILLACS WITH ALUMINUM WHEELS
Some 1988-1993 Cadillacs with aluminum wheels may incur cosmetic damage during balancing if proper care and procedures are not used. All
aluminum wheels have a clear coat paint on them that must be cared for like any other painted surface.
Some off-car wheel balancer retaining cups used to clamp the wheel to the balancer may put a circular mark into the clear coat on the face of the wheel.
Like any other clear coat damage this may be difficult to remove or repair, depending on severity.
ALWAYS use balancer retainer cups that are protected with rubber, plastic, or other non-metallic materials where contact is made with the wheel. Make
sure the retainer cup is free from dirt, grease, and gouges. Most wheel balancers now offer this type of protected retainer.
DO NOT allow the retainer cup to rotate against the wheel's surface when tightening the wheel to the balancer.
DO NOT OVERTIGHTEN. Most balancers use a large "wing nut" design to clamp the retainer against the wheel. Hand tight is sufficient.
This procedure will allow accurate balancing using the conventional back cone method.
IMPORTANT:
Coated balance weights must be used on aluminum wheels to prevent damage to the rim flange.
