Seville V8-4.6L VIN 9 (1995)
1995 Oldsmobile Aurora Fuel Chassis Line Removal and Installation
1995 Oldsmobile Aurora Fuel Chassis Line Removal and Installation
The following procedure is for replacing the fuel lines from the fuel rail on the engine back to and including the fuel filter under the vehicle. The
new fuel lines come complete with all necessary retainers. It applies only to the 1995 Oldsmobile Aurora and is based on the fuel rail being
replaced at the same time. Therefore the steps or procedures for relieving fuel pressure, disconnecting the lines from the fuel rail, etc., can be
found in the fuel rail replacement section of this recall bulletin.
1.
Disconnect the fuel lines (5) from the underhood retainers on the throttle body and body sheet metal (4).
2.
Separate the cruise control cable from the retainer.
3.
Remove the retainers from the body sheet metal and throttle body and discard.
4.
Using a sharp utility knife, cut off the plastic fuel lines where they meet the steel fuel lines (1) near the vacuum brake booster.
5.
Disconnect the evaporative emission hose.
6.
Remove the two nuts that attach the ABS module to the left strut (shock) tower.
7.
Remove the ABS module and disconnect the electrical connector.
8.
Partially raise the vehicle on a suitable hoist and support.
