Seville STS V8-4.6L VIN 9 (1998)
Brake Switch (Cruise Control): Service and Repair
Cruise Release Switch Adjustment
Cruise Release Switch Adjustment
IMPORTANT: Do not depress the brake pedal during adjustment procedure.
1. Insert release switch (2) into retainer until fully seated against the brake pedal arm.
2. Twist the switch to lock into position.
Measure
Measure the distance from the end of the barrel on the switch to the pedal arm, assure clearance is 1.5 mm to 1.7 mm (1/16 in). If not perform
steps 1 and 2 again.
Measure
The following pedal travel statement can be used to check for proper adjustment of the release switches.
^
Release switch assemblies must be closed at 3.5 to 12.5 mm (1/8 to 1/2 in) brake pedal travel, measured at the centerline of the brake pedal
assembly.
^
Nominal actuation of the release assembly contacts is about 4.5 mm (3/16 in).
