Seville STS V8-4.6L VIN 9 (1998)
10.
File a chamfer on the front face of engine block where the power steering pump mounting bracket locating pad is located so that the sharp corner
has been eliminated (Figure 5). Do not file the power steering pump mounting bracket.
11.
Reinstall the power steering pump and bracket assembly, making sure to push and hold the pump toward the rear of the engine while tightening the
attaching bolt. (The proper torque for the bolt is 50 N.m (37 lb. ft). Verify that there is no gap between the power steering pump bracket locating
ear and the engine block (Figure 6). Add power steering fluid as necessary to fill the power steering system.
12.
Install the appropriate new accessory drive belt for the vehicle being serviced as specified in the Parts Information section of this bulletin.
13.
Start the engine and verify that all components removed have been reassembled properly.
14.
Check power steering fluid level, and add fluid if necessary.
15.
Return vehicle to customer.
