Seville STS V8-4.6L VIN 9 (1998)
8.
Remove any flash from the mold parting lines in the belt contact area of the power steering pump pulley (Figure 3). Flash can be detected by
running your finger nail perpendicular to the grooves in the pulley. Use a piece of 400 grit sandpaper folded into a "V" or a small smooth file to
remove all flash from the entire belt contact area of the power steering pump pulley. Continue to sand the pulley until the flash can no longer be
detected in the entire belt contact area by running your finger nail perpendicular to the grooves in the pulley. Thoroughly clean the pulley with
shop air and a clean shop towel after removing the flash.
9.
Remove the dust cap and check the power steering pump pulley to shaft flushness with a straight edge (Figure 4). If necessary, adjust the pulley so
it is flush with the power steering pump shaft using pulley installer tool J 25033-B, and remover tool J 38825.
