Seville STS V8-4.6L VIN 9 (1998)
4. Squeeze the accelerator control cable (1) cover tangs and push the accelerator control cable through dash panel (bulkhead).
5. Remove the left instrument panel sound insulator.
6. Disconnect the accelerator control cable (1) at the accelerator controls pedal (3).
7. Remove the accelerator control cable.
Installation Procedure
Notice: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2 in)
of moving parts, unless the routing is positively controlled.
1. Install the accelerator control cable (3) at the throttle body lever (2).
2. Install the accelerator control cable (3) at the accelerator controls cable bracket (1).
Important: Accelerator control cable must be routed through groove in throttle body lever and seated securely.
