Seville STS V8-4.6L VIN 9 (1998)
4. Install the air cleaner cover (3) onto the air inlet housing.
5. Rotate the intake air duct/resonator assembly into place.
6. Snap the assembly clamps into place.
7. Install the screw on the intake air duct/resonator assembly.
Tthe air intake duct/resonator assembly screw to 10 N.m (7 lb ft).
8. Connect the negative battery cable.
Notice: The PCM will be damaged if proper programming procedures are not followed.
9. If a replacement PCM is being installed it must be programmed (flashed) using the latest Techline programming procedures.
10. Start the engine. If the engine tails to start verify the following:
^
The PCM contains the correct program
^
The PCM connectors are fully engaged into the PCM.
^
That all fuses are present and not blown.
11. Connect a scan tool and perform the following:
^
Clear DTC P0603.
^
Reset Transaxle fluid life to that recorded prior to PCM removal.
^
Reset Engine oil life to that recorded prior to PCM replacement.
