Seville STS V8-4.6L VIN 9 (1998)
2. Reinstall the fuel sender assembly (3) and the fuel sender assembly retainer cam (2) using the J 39765 Fuel Sender Spanner Wrench (1).
3. Connect the electrical connector at the fuel tank pressure sensor.
4. Connect the electrical connector at the fuel sender assembly.
5. Connect the negative battery cable.
6. Inspect for leaks.
Turn the ignition switch ON for 2 seconds.
Turn the ignition switch OFF for 10 seconds.
Turn the ignition switch ON.
Check for fuel leaks.
Notice: Refer to Fastener Notice in Service Precautions.
7. Reinstall the fuel sender access panel (2).
Tighten the fuel sender access panel bolts to 2 N.m (18 lb in).
8. Reinstall the rear compartment floor trim (1).
9. Reinstall the spare tire, the jack, and the spare tire cover.
