Seville STS V8-4.6L VIN 9 (1998)
INSTALLATION PROCEDURE
Ignition Switch Lock Cylinder Replacement: Installation Procedure
1. Install the ignition cylinder cover (2) and light pipe (3) onto ignition cylinder and engage the retainers.
2. Slide the reader/exciter (4) onto ignition cylinder and align to slot on cylinder.
3. Install the ignition cylinder bezel on the cylinder and engage retainers.
Ignition Switch Lock Cylinder Replacement: Installation Procedure
4. Insert the ignition lock cylinder (1) with the key installed into the ignition switch (2).
5. Press the ignition lock cylinder into place. The lock cylinder retaining tab will produce an audible click.
6. Check to be sure that the ignition lock cylinder is fully engaged.
^
Use light force to pull lock cylinder and attempt to remove it.
^
The lock cylinder should not be removable.
7. Turn the ignition to LOCK, then remove the key.
8. Install the radio/heater and A/C control.
9. Release the parking brake.
10. Check the ignition switch for proper operation in all positions.