Seville STS V8-4.6L VIN 9 (1998)
IMPORTANT: Do not allow clearing solution to enter the outside moisture sensor module. Cleaning solution will damage the sensor module. If
this occurs, the sensor module must be replaced.
5. Using a lint free cloth arid cleaning solution, wipe the remaining tape residue off the optical area.
Repeat the previous step as needed. Less soaking time will be required as the amount of tape residue becomes less.
6. Clean the tray of all tape residue and solution.
INSTALLATION PROCEDURE
Outside Moisture Sensor Replacement (Rain Sensor - New Windshield): Installation Procedure
1. Mark the location of the sensor (1) on the outside of the windshield.
Use a water soluble marker or tape in order to mark the sensor locations in the following manner:
1.1.
Draw a line (2) perpendicular to the top of the windshield (5) 6 cm (2.375 in) to the right of the passenger side edge of the rear view mirror
mount (4).
1.2.
Draw a line (3) parallel to the top of the windshield (5) 2 cm (.750 in) from the bottom of the rear view mirror mount (4). This line should
cross the vertical line.
Outside Moisture Sensor Replacement (Rain Sensor - New Windshield): Installation Procedure
2. Install the optical tape (2) to the rain sensor module (1).
IMPORTANT: Do not touch the optical tape adhesive. Replace the optical tape (2) if the tape is touched or contaminated.
