Seville STS V8-4.6L VIN 9 (1998)
fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or
other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint
clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these
instructions can help you avoid damage to parts and systems.
1. Install the bracket on the height sensor with four nuts.
Tighten four nuts to 3 Nm (26 inch lbs.).
2. Install the height sensor with the bracket on the vehicle with two bolts.
Tighten two bolts to 11 Nm (97 inch lbs.).
3. Connect the link to the height sensor actuating arm.
4. Connect the height sensor harness clip and the connector to the vehicle.
5. Connect the height sensor connector to the vehicle harness connector.
6. Lower the vehicle.
7. Adjust the height sensor. Refer to TRIM HEIGHT SENSOR Adjustment (w/o Road Sensing Suspension).
