Seville STS V8-4.6L VIN 9 (1998)
Power Steering Fluid: Service and Repair
Discolored, Foam or Bubbles In the Power Steering Fluid
If the power steering fluid is discolored or there is foam or bubbles, proceed with the following instructions:
1. Turn OFF the ignition. Wait two minutes.
2. Recheck the hose connections.
3. Start the engine.
4. Maintain the power steering fluid level with the engine idling (1).
5. Install the cap.
6. Return the wheels to center.
7. Lower the front wheels to the ground.
8. Keep the engine running for two minutes.
9. Turn the steering wheel in both directions.
10. If the condition continues, check and repair or replace the following:
^
The return hose clamps and O-rings.
