Seville STS V8-4.6L VIN 9 (1998)
Cross-Member: Service and Repair
Support Replacement
REMOVAL PROCEDURE
1. Raise and support vehicle.
2. Remove the wheels and tires.
3. Lower exhaust system. Refer to EXHAUST SYSTEM Replacement.
4. Remove the springs. Refer to COIL SPRING Replacement.
5. Remove the brake calipers and support. Refer to BRAKE CALIPER Replacement.
6. Disconnect the wheel speed sensor electrical connector from each wheel.
7. Release the park brake cable from brake calipers.
8. Loosen the parking brake cable (1) and then disconnect the cable at the rear suspension support assembly.
9. Disconnect the electrical connectors from the support assembly.
10. Remove the electronic level control electrical connector and vent hose.
